New to AI? Start here → Start 1. What can you do with Claude?

Last checked: November 10, 2026

Understand Claude Code's permission requests

In one line

These days Claude Code starts in auto mode and goes ahead with work inside the working folder without asking. While you’re learning, switch to manual mode and approve each step as you watch. Just remember: if you read it and it makes sense, Yes; if you’re not sure, No, and ask.

The big picture

★ Three ways to answer a permission request ★

1. Yes

Allow just this once

The one you'll use most at first.

2. Always allow

Don't ask again for the same kind

For repeated jobs you trust

3. No

Say no and tell it to do it differently

The Esc key does the same.

Not sure? Say No and ask!

Follow along

Step 1. Switch to manual mode

Since Claude Code v2.1.283, auto mode is the default. If you see ⏵⏵ auto mode on at the bottom of the screen, you’re in auto mode. In this mode, it creates, edits, and moves files inside the working folder without asking, and only blocks or asks about things that look risky.

When you’re first practicing, press Shift + Tab so ⏸ manual mode on shows at the bottom of the screen. Then it asks every time before changing anything.

Step 2. Read the permission request

The permission request shows what it’s about to do.

Illustration (may look a little different from the real screen)

Sample replyDo you want to run this command?

mkdir photos && mv *.jpg photos/
(Creates a "photos" folder and moves the jpg files into it)

❯ 1. Yes
2. Yes, and don't ask again for mkdir commands
3. No, and tell Claude what to do differently (esc)

Step 2: Claude Code shows what it's about to do and asks

It’s fine if the command looks unfamiliar. There’s usually an explanation of what it does in parentheses or just above it. If there’s no explanation, choose No and ask, “What does this command do?”

Step 3. When to say No

Choose No and Claude Code stops and waits for you. Tell it to do it differently, like “Don’t delete them. Move them to a ‘to-delete’ folder instead.”

Step 4. Know the four modes

Each time you press Shift + Tab, the mode shown at the bottom of the screen changes. From auto mode, press it once for manual, then accept edits, then plan mode.

Whatever the mode, the habit of saying “Just show me the plan first, don’t change anything yet” is your most reliable safety net. Mode names may differ a little by version.

Where people get stuck

Lots of people get stuck here. Find the one that matches your situation!

“It asks so often it’s annoying”

If it’s a job you trust, choose “always allow.” Still, for the first few weeks, it’s good to build the habit of reading each one.

“I heard there’s a way to skip permissions entirely?”

There is, but I don’t recommend it. You lose the chance to stop Claude Code when it makes a mistake. If you really need it, only use it somewhere it’s fine if things break, like a copy of a folder.

“I want to undo an ‘always allow’”

Type /permissions in Claude Code to see the allowed list and remove items.

Next tip

Make a memory note for Claude Code →

I'm stuck here

Stuck while following along? Tell me where. Only the site owner sees this. Leave your email only if you'd like a reply.